ULTIMA anti-bird wire system
* Screw for rod UBS-T01, UBS-T02, and UBS-T00 are not included because the substrate material is different.
|
【Important】 Installation of stainless-steel rod UBS-T01 (02)、rod UBS-T00
|
When installing the stainless-steel rod UBS-T01(02), be sure to install them 30-40 mm inside the top of the structure.
It is recommended to install the stainless-steel rod UBS-T00 (base only, for wall mounting) at a height of 100 mm above the structure.
Screws are not included in the shipment, as the type of screw varies depending on the mounting substrate.
It is necessary to select screws that match the mounting substrate.
Since these are generally difficult, we recommend that the installation be done by a professional contractor or a construction company.
|
Anti-bird wire roll ＋ Spring grip
|
| Situation |
If you have approximate quantities of the required components |
| Example |
Total wire length: about L=1,000m |
| Advantages |
|
| Disadvantages |
|
＊The wire roll and spring grip are sold as a set, and the spring grip is not sold separately.
We cannot be held responsible for any problems that may occur if the spring grips are used for purposes other than our wire or anti-bird wire.
|
Products Specifications_wire roll ＋ spring grip
|
|
ULTIMA anti-bird wire roll (φ1.2) ＋ SUS spring with grip (φ1.2)
|
|
UBW-100 |
|
| Wire length | 100m roll |
| Material | SUS304 (7×7) |
| Wire | coated stainless wire φ1.2 |
|
UBW-Grip |
|
| Material | Spring：SUS304、Grip：brass、Wire：SUS304 (7×7) |
| Finishing | Grip：Nickel plating |
| Note | Sold as a set minimum of 50 springs with grips for 100m rolls |
＊ UBW roll is φ1.2mm
＊ Sold as a set of 50 springs with grips for 100m rolls
＊ Wire tension is generally kept level visually.
＊ Do not over-tension both end springs.
＊ Shape and specifications are subject to change without notice.
|
ULTIMA anti-bird wire roll (φ0.8) ＋ SUS spring with grip (φ0.8)
|
|
UBWM-100 |
|
| Wire length | 100m roll |
| Material | SUS304 (7×7) |
| Wire | stainless wire φ0.8 |
|
UBWM-Grip |
|
| Material | Spring：SUS304、Grip：brass、Wire：SUS304 (7×7) |
| Finishing | Grip：Nickel plating |
| Note | Sold as a set minimum of 50 springs with grips for 100m rolls |
＊ UBWM roll is φ0.8mm.
＊ Sold as a set minimum of 50 springs with grips for 100m rolls
＊ Wire tension is generally kept level visually.
＊ Do not over-tension both end springs.
＊ Shape and specifications are subject to change without notice.
|
Products Specifications_rod
|
|
ULTIMA stainless-steel rod ＊ photo shows 2-tier wire specification
|
|
|
UBS-T01 (1 tiered-wire) UBS-T02 (2 tiered-wire) |
| Material |
SUS304 |
| Note |
With sealer for waterproofing
Common end and middle |
＊ Screws are not included because the substrate material is different.
＊ Recommended rod pitch is 2m.
＊ For wall mounting, use only the base.
＊ If waterproofing is required, waterproof the screws after mounting the base.
ULTIMA stainless-steel rod must be installed 30 to 40 mm inside from the tip of the structure.
| UBW series (wire φ1.2) |
|
＊ The spring pull guideline is within 1.5 times (about 50～55mm). ＊ The middle rod should be installed at a pitch of 2,000 mm. |
| UBWM series (wire φ0.8) |
|
＊ The spring pull guideline is within 1.5 times (about 30 mm). ＊ The middle rod should be installed at a pitch of 2,000 mm. |
|
ULTIMA stainless-steel rod
|
|
|
UBS-T00 【base only for wall mounting】 |
| Wire (tier) | single |
| Material |
SUS304 |
| Note |
With sealer for waterproofing
Common end and middle |
＊ Screws are not included because the substrate material is different.
＊ If waterproofing is required, waterproof the screws after mounting the base.
It is recommended to install the stainless-steel rod UBS-T00 (base only, for wall mounting) at a height of 100 mm above the structure.
Rod cannot be attached to the structure, but it can be installed when it is possible to attach it to the wall.
As an example of installation, install the UBS-T00 (base only for wall mounting) and attach the anti-bird wire set to the hole in the base.
The anti-bird wire set to be used is UBW series or UBW-B series with wire diameter φ1.2.
|
ULTIMA stainless-clamp rod ＊ photo shows 2-tier wire specification
|
|
|
UBS-FN1-1 (1 tiered-wire) UBS-FN1-2 (2 tiered-wire) |
|
Flange thickness |
3mm～12mm |
| Material | Rod：SUS304、Base：steel |
| Finishing | hot-dip galvanizing |
| Attached | M6 L=25mm (vibration support and loosening bolt included) |
| Note | Common end and middle |
|
|
UBS-FN2-1 (1 tiered-wire) UBS-FN2-2 (2 tiered-wire) |
|
Flange thickness |
3mm～16mm |
| Material | Rod：SUS304、Base：steel |
| Finishing | hot-dip galvanizing |
| Attached | M6 L=25mm (vibration support and loosening bolt included) |
| Note | Common end and middle |
|
|
UBS-FN3-1 (1 tiered-wire) UBS-FN3-2 (2 tiered-wire) |
|
Flange thickness |
9mm～24mm |
| Material | Rod：SUS304、Base：steel |
| Finishing | hot-dip galvanizing |
| Attached | M6 L=25mm (vibration support and loosening bolt included) |
| Note | Common end and middle |
＊ Loosening bolt are included, but the bolt must be securely fastened.
＊ Recommended rod pitch is 2m.
| UBW series (wire φ1.2) |
|
＊ The spring pull guideline is within 1.5 times (about 50～55mm). ＊ The middle rod should be installed at a pitch of 2,000 mm. |
| UBWM series (wire φ0.8) |
|
＊ The spring pull guideline is within 1.5 times (about 30 mm). ＊ The middle rod should be installed at a pitch of 2,000 mm. |